DTC C1128-2A: Electric Parking Brake Switch Circuit Malfunction: Notes
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| Description |
Electric parking brake switch circuit malfunction |
| Detection condition |
- Electric parking brake control module detects the operation or release of the electric parking brake switch for a continuous 30 s while the vehicle is stopped.
|
| Fail-safe |
- The electric parking brake control module operates the electric parking brake under any of the following conditions while the vehicle is stopped.
- Ignition is switched ON (engine off or on) and selector lever is in P or N position (ATX)
- Ignition is switched ON (engine off or on) and shift lever is in neutral position (MTX)
- Ignition is switched ON (engine off or on) and driver's door is open from closed condition
- Ignition is switched off and brake pedal is depressed
- Ignition is switched off and driver's door is open
|
| Possible cause |
CAUTION:
- When the electric parking brake switch is continuously pulled up/pressed down for a long period, DTCs may be detected. Therefore, always verify that DTCs being detected are due to how the customer has operated the switch.
- Electric parking brake switch malfunction
- Electric parking brake switch is mechanically stuck
- Electric parking brake control module malfunction
|
| System wiring diagram |
Not applicable |