Clip Installation Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Install a new clip to the clip groove at the end of the rear drive shaft with the clip opening facing upward.

Fig 1: Installing Clip To Rear Drive Shaft End
Courtesy of MAZDA MOTORS CORP.
Verify that the outer diameter of the clip is within the specification.
SPECIFICATION
- Less than 25.2 mm {0.992 in}
- If it exceeds the specification, repeat installation using a new clip.