Tripod Joint, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Assemble the tripod joint with the alignment marks on the shaft and tripod joint aligned.
CAUTION:
- When using the hammer and urethane bar or equivalent, be careful not to scratch the roller area so as to prevent damage to the part.
NOTE:
- If the tripod joint cannot be assembled to the shaft, lightly tap the tripod joint evenly using a hammer and urethane bar or equivalent, and assemble the tripod joint to the shaft.
Fig 1: Identifying Alignment Marks On Shaft And Tripod Joint
Courtesy of MAZDA MOTORS CORP.
Assemble a new snap ring using snap ring pliers.

Fig 2: Assembling Snap Ring Using Snap Ring Pliers
Courtesy of MAZDA MOTORS CORP.
Verify that the snap ring is assembled correctly in the groove of the shaft.