Snap Ring, Tripod Joint Disassembly Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Place alignment marks on the shaft and tripod joint.
CAUTION:
- To prevent damage to parts, do not use a punch or similar tool to place alignment marks. Use paint.
Fig 1: Identifying Alignment Marks On Shaft And Tripod Joint
Courtesy of MAZDA MOTORS CORP.
Remove the snap ring using snap ring pliers.

Fig 2: Removing Snap Ring Using Snap Ring Pliers
Courtesy of MAZDA MOTORS CORP.
Remove the tripod joint from the shaft.
CAUTION:
- When using the hammer and urethane bar or equivalent, be careful not to scratch the roller area so as to prevent damage to the part.
NOTE:
- If the tripod joint cannot be removed from the shaft, lightly tap the tripod joint evenly using a hammer and urethane bar or equivalent, and remove the tripod joint from the shaft.
Wipe off grease on the shaft and tripod joint using a clean rag.