LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Dynamic Stability Control (Service Information)) >> DSC HU/Cm Removal/Installation >> DSC HU/CM Connector Removal Note

DSC HU/CM Connector Removal Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the lock lever down in the direction of the arrow while pressing the tab of the connector cover.
    Fig 1: Pulling Lock Lever Down
    G10936926Courtesy of MAZDA MOTORS CORP.
  2. Pull the connector toward the vehicle rear and remove it.