Diagnostic Procedure

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	Perform immobilizer system-related part programming. Perform start stop unit replacement and programming due to simultaneous replacement of start stop unit/PCM. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING .) Clear DTC for the immobilizer system using the M-MDS. (See CLEARING DTC [IMMOBILIZER SYSTEM] .) Perform the DTC inspection for the immobilizer system using the M-MDS. (See DTC INSPECTION [IMMOBILIZER SYSTEM] .) Security indicator light: 23, DTC B10DA:62/P1260:00 displayed?	Yes	Go to the next step.
1		No	Go to Step 3.
2	PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS PCM Clear DTC for the immobilizer system using the M-MDS. (See CLEARING DTC [IMMOBILIZER SYSTEM] .) Perform the DTC inspection for the immobilizer system using the M-MDS. (See DTC INSPECTION [IMMOBILIZER SYSTEM] .) Security indicator light: 23, DTC B10DA:62/P1260:00 displayed?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
2		No	Go to the next step.
3	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [IMMOBILIZER SYSTEM] .)
3		No	DTC troubleshooting completed.