Diagnostic Procedure
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY NUMBER OF PROGRAMMED REMOTE TRANSMITTER
|
Yes | Perform additional remote transmitter programming, then go to the next step. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING .) |
| No | Go to the next step. | ||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [IMMOBILIZER SYSTEM] .) |
| No | DTC troubleshooting completed. | ||