Diagnostic procedure
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY DTC OUTPUT STATUS
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL, FW6AX-EL] .) |
| No | Go to the next step. | ||
| 2 | INSPECT ATF LEVEL
|
Yes | Adjust the ATF level to the specification, then go to the next step. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [FW6A-EL, FW6AX-EL] .) |
| No | Go to the next step. | ||
| 3 | PERFORM ON-BOARD DIAGNOSTIC TEST TO SPECIFY MALFUNCTIONING PART
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL, FW6AX-EL] .) |
| No | ATF amount in Step 2 is correct:
ATF amount adjusted in Step 2:
|
||