DTC P0717-00: Open Circuit In Turbine/Input Shaft Speed Sensor Circuit: Notes
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| DTC P0717:00 |
Open circuit in turbine/input shaft speed sensor circuit |
| DETECTION CONDITION |
- Under the following conditions, the turbine/input shaft speed sensor signal is not input for 1 s
:
- Engine is running.
- Vehicle speed signal related DTC is not recorded.
- Vehicle speed is 16 km/h {9.9 mph} or more
.
- There is no difference between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal.
- DTC U0121:00 is not recorded.
|
| FAIL-SAFE FUNCTION |
- Set to TCC control.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
- Inhibits 5GR and 6GR.
- Inhibits shift down when the accelerator pedal is depressed.
|
| POSSIBLE CAUSE |
- Turbine/input shaft speed sensor malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |