Diagnostic Assist Code "70" Display/Touch Panel Inspection
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Input diagnostic assist code "70" according to the diagnostic assist code input procedure. (See DIAGNOSTIC ASSIST CODE INPUT PROCEDURE .)NOTE:
- The display/touch panel inspection is repeated periodically until a same location in the center display is touched for 10 s or more .
Inspection Display of center display (Diagnostic result) Action - Launch the display/touch panel inspection mode.
- Verify the center display.
- Does the center display display normally?
If normal, [+] cursor is displayed centering around the touched area, and at the same time, the display switches in the following order. - Unicolor screen in the following colors
- White→Black→Red→Green→Blue
- Horizontal-striped screen in black and the following colors
- Red→Green→Blue
- Vertical-striped screen in black and the following colors
- Red→Green→Blue
- Checkered screen in black and the following colors
- Red→Green→Blue
- Returns to 1.
Yes Center display is normal. No Replace the center display.
(See CENTER DISPLAY REMOVAL/INSTALLATION .) - Continuously touch the same location for 10 s or more
.NOTE:
- If the display/touch panel inspection is finished, the diagnostic assist function is canceled without returning to the diagnostic assist code input screen.
- If the diagnostic assist function is canceled, it returns to a different screen depending on the way in which the diagnostic assist function was launched.
- If launched using the commander switch: The screen directly before launching the diagnostic assist function
- If launched not using the commander switch: The display setting screen