DTC C0063:54 [Radar Unit]: Notes
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| System malfunction location |
MRCC system initialization not implemented |
| Detection condition |
- The initial setting for yaw rate information is not performed after replacing the SAS control module.
NOTE:
- If the ignition is switched off (LOCK) when an error occurs during the system initialization command execution, a DTC is detected indicating that the system initialization was not performed.
|
| Fail-safe |
- Inhibits the Mazda radar cruise control (MRCC) system control
- Inhibits the smart brake support (SBS) system control
|
| Possible cause |
- MRCC system initialization not performed after replacing SAS control module
- SAS control module malfunction
- Radar unit malfunction
|
| System wiring diagram |
|