Airflow Mode Actuator
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON.
- Start the engine.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Body".
- Select the "EATC Operation Check".
- Select the "Airflow Mode Actuator" from the screen menu.
- Verify the A/C operation check mode according to the directions on the screen.
- Select "Stop" to stop the A/C operation check. (See A/C OPERATION CHECK STOP .)
OPERATION DESCRIPTION
| Step | Air mix actuator | Airflow mode actuator | Blower speed | Magnet clutch | Air intake actuator |
|---|---|---|---|---|---|
| 1 | 50 % | VENT | 5th | ON | FRESH |
| 2 | BI-LEVEL | ||||
| 3 | HEAT | ||||
| 4 | DEF/HEAT | ||||
| 5 | DEFROSTER |
TEMPERATURE DISPLAY
| Step | Temperature (°C {°F}) | Airflow mode | Blower volume | A/C | A/C switch indicator light | Recirculate switch indicator light | Fresh switch indicator light |
|---|---|---|---|---|---|---|---|
| 1 | 3 | Dash Outlet | 5th Bar | Displayed | Illuminated | Not illuminated | Illuminated |
| 2 | Dash & Floor Outlets | ||||||
| 3 | Floor Outlet | ||||||
| 4 | Defrost & Floor Outlets | ||||||
| 5 | Defrost Outlet |
NOTE:
- After approx. 11 s have elapsed the operation step moves to the next step.
- When the last step is finished, the operation is repeated from Step 1.
- To prevent super-cooling, the magnetic clutch turns off despite the A/C forced override.