DTC P061B-00: Internal Control Module Torque Calculation Performance Problem: Notes

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

DTC P061B:00	Internal control module torque calculation performance problem
DETECTION CONDITION	Indicates an error occurred in the PCM. There is a malfunction in the sensor input signal to the PCM. Diagnostic support note This is a continuous monitor (CCM). The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA (Mode 2)/Snapshot data is available. DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	Restricts the upper limit of the engine speed.
POSSIBLE CAUSE	PCM connector or terminals malfunction PCM malfunction
System Wiring Diagram	Not applicable