LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (On-Board Diagnostic - Engine Controls (2 Of 4)) >> DTC P0610-00: Pcm Vehicle Configuration Error >> Notes

DTC P0610-00: Pcm Vehicle Configuration Error: Notes

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0610:00 PCM vehicle configuration error
DETECTION CONDITION 
  • PCM data configuration error.

    Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION  Not applicable
POSSIBLE CAUSE 
  • Configuration procedure has not been completed
  • PCM connector or terminals malfunction
  • PCM malfunction
System Wiring Diagram  Not applicable
scientia non olet · About LEMON Manuals