DTC P0602-00: Pcm Programming Error: Notes
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| DTC P0602:00 |
PCM programming error |
| DETECTION CONDITION |
- No configuration data in the PCM.
NOTE:
- If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the check engine light (system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
- The check engine light turns off after three drive cycles with no malfunction (DTCs remain in PCM).
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
Not applicable |
| POSSIBLE CAUSE |
- Configuration has not been completed
- PCM connector or terminals malfunction
- PCM malfunction
|
| System Wiring Diagram |
Not applicable |