LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (On-Board Diagnostic - Engine Controls (3 Of 4)) >> DTC P253F-00: Engine Oil Malfunction >> Function Inspection Using M-MDS

Function Inspection Using M-MDS

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION RESULTS ACTION
1 PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 PURPOSE: VERIFY IF DIAGNOSTIC RESULT IS AFFECTED BY DTC RELATED TO INSTRUMENT CLUSTER 
  • Switch the ignition off, then ON (engine off).
  • Perform the instrument cluster DTC inspection using the M-MDS.

    (See DTC INSPECTION [INSTRUMENT CLUSTER] .)

  • Are any DTCs present?
 Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [INSTRUMENT CLUSTER] .)
No Go to the next step.
3 PURPOSE: VERIFY THAT NO OTHER DTCs ARE RECORDED 
 Yes Go to the applicable PENDING CODE or DTC inspection.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
Go to the troubleshooting procedure to perform the procedure from Step 1.
No Go to the troubleshooting procedure to perform the procedure from Step 1.
scientia non olet · About LEMON Manuals