LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (On-Board Diagnostic - Engine Controls (1 Of 4)) >> DTC P0116-00: ECT Sensor No. 1 Circuit Range/Performance Problem >> Details On DTCs

Details On DTCs

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
DESCRIPTION ECT sensor No. 1 circuit range/performance problem
DETECTION CONDITION  Determination conditions
  • During the 5 min  after the engine is started, the engine coolant temperature does not increase above 6 °C {11 °F}. 
Preconditions
  • Before starting the engine, leave the vehicle with the engine turned off for 6 hours or more  .
  • The following DTCs are not detected:

  • ECT sensor No. 1: P0117:00, P0118:00
Drive cycle
Self test type
  • CMDTC self test
Sensor used
  • ECT sensor No. 1
FAIL-SAFE FUNCTION 
  • Not applicable
VEHICLE STATUS WHEN DTCs ARE OUTPUT 
  • Illuminates check engine light.
POSSIBLE CAUSE 
  • ECT sensor No. 1 connector or terminals malfunction
  • PCM connector or terminals malfunction
  • ECT sensor No. 1 loose
  • ECT sensor No. 1 malfunction
  • Poor assembly of engine coolant hose (engine coolant passage malfunction)
  • Poor engine coolant, leakage, or freezing
  • Use of unspecified engine coolant
  • Thermostat malfunction
  • PCM malfunction