Repeatability Verification Procedure

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Warm up the engine to allow the engine coolant temperature to reach 80 °C {176 °F} or more .
Start the engine and leave it idling for 1 min.

NOTE:

The target calculated by the PCM is increased and the DTC determination conditions are met by repeating the Step 3 operation.
Shift to 1st gear and accelerate/decelerate the vehicle to 30-50 km/h {19-31 mph} .

NOTE:

Match the engine coolant temperature in the recorded FREEZE FRAME DATA/snapshot data, the vehicle speed, and engine speed values to the best extent possible while driving the vehicle.

Try to reproduce the malfunction by driving the vehicle for 5 min based on the values in the FREEZE FRAME DATA/snapshot data.