LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Seat Belt) >> Rear Center Seat Belt Removal/Installation >> Notes

Rear Center Seat Belt Removal/Installation: Notes

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor.
NOTE:
  • The rear center seat belt is building into the rear seat back.
  1. Press the release switch, then disconnect the rear center seat belt and rear buckle.
    Fig 1: Identifying Release Switch, Rear Center Seat Belt And Rear Buckle (LH)
    G10938000Courtesy of MAZDA MOTORS CORP.
  2. Remove the rear seat back. (See REAR SEAT BACK REMOVAL/INSTALLATION .)
  3. Remove the rear seat back frame. (See REAR SEAT BACK FRAME REMOVAL/INSTALLATION .)
  4. Remove the nuts as shown in the figure.
    Fig 2: Identifying Rear Center Seat Belt And Nuts With Torque Specification
    G10938001Courtesy of MAZDA MOTORS CORP.
  5. Remove the rear center seat belt.
  6. Install in the reverse order of removal. (See REAR CENTER SEAT BELT INSTALLATION NOTE .)
scientia non olet · About LEMON Manuals