LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (On-Board Diagnostic - Adaptive Front Lighting System) >> DTC B1041-14: Headlight Leveling Actuator Circuit Malfunction >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
Step Inspection Action
1 INSPECT FRONT COMBINATION LIGHT (LH) CONNECTOR CONDITION 
Yes Go to the next step.
No Repair or replace the connector, then go to Step 7.
2 INSPECT FRONT COMBINATION LIGHT (RH) CONNECTOR CONDITION 
  • Disconnect the front combination light (RH) connector.
  • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
  • Is the connector normal?
Yes Go to the next step.
No Repair or replace the connector, then go to Step 7.
3 INSPECT AFS CONTROL MODULE CONNECTOR CONDITION 
  • Disconnect the AFS control module connector.
  • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
  • Is the connector normal?
Yes Go to the next step.
No Repair or replace the connector, then go to Step 7.
4 INSPECT HEADLIGHT LEVELING ACTUATOR CIRCUIT FOR SHORT TO GROUND 
  • Verify that the following connectors are disconnected.
    • Front combination light (LH)
    • Front combination light (RH)
    • AFS control module
  • Inspect for continuity between the following terminals (vehicle wiring harness side) and body ground.
    • Front combination light (LH) terminal I
    • Front combination light (LH) terminal F
    • Front combination light (RH) terminal I
    • Front combination light (RH) terminal F
  • Is there continuity?
Yes Repair or replace the wiring harness which is shorted to ground, then go to Step 7.
No Go to the next step.
5 INSPECT HEADLIGHT LEVELING ACTUATOR CIRCUIT FOR OPEN CIRCUIT 
  • Verify that the following connectors are disconnected.
    • Front combination light (LH)
    • Front combination light (RH)
    • AFS control module
  • Inspect the wiring harness between the following terminals (vehicle wiring harness side) for continuity.
    • AFS control module terminal P and front combination light (LH) terminal I
    • AFS control module terminal O and front combination light (LH) terminal F
    • AFS control module terminal P and front combination light (RH) terminal I
    • AFS control module terminal O and front combination light (RH) terminal F
  • Is there continuity?
Yes Go to the next step.
No Repair or replace the wiring harness which has an open circuit, then go to Step 7.
6 INSPECT HEADLIGHT LEVELING ACTUATOR OPERATION 
Yes Go to the next step.
No Replace the front combination light, then go to the next step.
(See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .)
7 VERIFY THAT REPAIRS HAVE BEEN COMPLETED 
Yes Repeat the inspection from Step 1.
No Go to the next step.
8 VERIFY IF OTHER DTCs DISPLAYED 
  • Are any other DTCs displayed?
Yes Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [ADAPTIVE FRONT LIGHTING SYSTEM (AFS)] .)
No DTC troubleshooting completed.