BSM Control Module (LH)

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

-: Not applicable

PID name	Unit/Status	Data contents	Inspection item(s)
DTC_CNT	-	Displays number of DTCs stored in the BSM control module (LH)	BSM control module (LH)
IL_MODE	Off/On	Off: BSM OFF indicator light is illuminated in night mode. On: BSM OFF indicator light is illuminated in daytime mode.	BSM OFF indicator light (Instrument cluster)
RCTA_BUZZER	Off/On	Off: RCTA buzzer does not sound. On: RCTA buzzer sounds.	Audio unit
RCTA_OFF_IL	Off/On	Off: RCTA OFF indicator is turned off. On: RCTA OFF indicator is turned on.	Audio unit
RCTA_WARN	Off/On	Off: RCTA warning indicator is turned off. On: RCTA warning indicator is turned on.	Audio unit
SHIFT_R	Not_R/R	ATX: Not_R: Selector lever is in position other than R. R: Selector lever is in R position. MTX: Not_R: Shift lever is in position other than reverse. R: Shift lever is in reverse position.	ATX: Transaxle range sensor (TCM) MTX: Back-up light switch
SWA_POS	° (deg)	Displays steering angle signal (estimated absolute angle) Steering wheel in neutral position: Near 0 degrees Steering wheel turned to left: Changes from 0 degrees to positive Steering wheel turned to right: Changes from 0 degrees to negative	Perform the DTC inspection for the PCM, DSC HU/CM, and EPS CM, and if any DTC is displayed, repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) (See ELECTRIC POWER STEERING (EPS) ON-BOARD DIAGNOSIS [ELECTRIC POWER STEERING (EPS)] .) After performing the DTC inspection, perform the following procedures: Switch the ignition off, and after 2 min or more have elapsed, switch the ignition ON (engine off or on). Start the engine and drive the vehicle 10 m {33 ft} or more in a straight line at a speed of 10 km/h {6.2 mph} or more . Stop the vehicle with the wheels in the straight-ahead position. Verify the operation condition of STR_AB_ANG using the M-MDS. If an abnormal value is indicated again, replace the EPS CM. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
VPWR_IG1	V	Displays BSM control module (LH) power supply voltage	BSM control module (LH) IG1 relay Battery
VSPD	KPH, MPH	Displays vehicle speed	-
WRN_IND_L	Off/On	Off: BSM indicator light (LH) is not illuminated. On: BSM indicator light (LH) is illuminated.	BSM indicator light (LH)