Diagnostic Procedure
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM START STOP UNIT CONFIGURATION (AS-BUILT DATA USE)
|
Yes | Using the M-MDS, re-perform the start stop unit configuration using the As-Built data, then go to the next step. (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 5. | ||
| 2 | VERIFY IF INSTALLATIONS OF LIGHT SWITCH AND WIPER AND WASHER SWITCH ARE REVERSED
|
Yes | Go to the next step. |
| No | Install the light switch and the wiper and washer switch properly, then go to Step 4. | ||
| 3 | INSPECT TURN SWITCH
|
Yes | Go to the next step. |
| No | Replace the turn switch, then go to the next step. (See LIGHT SWITCH REMOVAL/INSTALLATION .) |
||
| 4 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
|
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .) |
| No | DTC troubleshooting completed. | ||