Diagnostic Procedure

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection		Action
1	INSPECT PUSH BUTTON START CONNECTOR CONDITION Switch the ignition to off. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Disconnect the push button start connector. Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. Is the connector normal?	Yes	Go to the next step.
1		No	Repair or replace the connector, then go to Step 6.
2	INSPECT PUSH BUTTON START SWITCH 1 CIRCUIT FOR OPEN CIRCUIT Verify that the push button start connector is disconnected. Inspect for continuity between push button start terminal G (vehicle wiring harness side) and body ground. Is there continuity?	Yes	Go to the next step.
2		No	Repair or replace the wiring harness which has an open circuit, then go to Step 6.
3	INSPECT START STOP UNIT CONNECTOR CONDITION Disconnect the start stop unit connector. Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. Is the connector normal?	Yes	Go to the next step.
3		No	Repair or replace the connector, then go to Step 6.
4	INSPECT PUSH BUTTON START SWITCH 1 CIRCUIT FOR OPEN CIRCUIT Verify that the push button start and start stop unit connectors are disconnected. Inspect the wiring harness for continuity between start stop unit terminal 1H (vehicle wiring harness side) and push button start terminal C (vehicle wiring harness side). Is there continuity?	Yes	Go to the next step.
4		No	Repair or replace the wiring harness which has an open circuit, then go to Step 6.
5	INSPECT PUSH BUTTON START SWITCH 1 Inspect push button start switch 1. (See PUSH BUTTON START INSPECTION .) Is push button start switch 1 normal?	Yes	Go to the next step.
5		No	Replace the push button start, then go to the next step. (See PUSH BUTTON START REMOVAL/INSTALLATION .)
6	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Reconnect all the disconnected connectors. Reconnect the disconnected negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Clear DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT] .) Switch the ignition ON (engine off or on) and press the push button start 5 times or more . Perform the DTC inspection for the start stop unit using the M-MDS. (See DTC INSPECTION [START STOP UNIT] .) Is DTC B108B:24 displayed?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .)
6		No	Go to the next step.
7	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .)
7		No	DTC troubleshooting completed.