LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Automatic Transaxle System (Service Information)) >> Oil Cooler Removal/Installation >> Water Hose Installation Note

Water Hose Installation Note

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the water hose to the oil cooler as shown in the figure with the hose clamp expanded.
    NOTE:
    • A new water hose and hose clamp are attached.
    Fig 1: Installing Water Hose To Oil Cooler
    G10937274Courtesy of MAZDA MOTORS CORP.
  2. Install the hose clamp to the position shown in the figure.
    Fig 2: Installing Hose Clamp
    G10937275Courtesy of MAZDA MOTORS CORP.
    • Verify that the installation angle of the hose clamp is within the range shown in the figure.
  3. Verify that the hose clamp does not interfere with any other components.
scientia non olet · About LEMON Manuals