Lateral Runout Inspection
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- To secure the disc plate and the hub, insert the washer (thickness 10 mm {0.39 in} , inner diameter more than 12 mm {0.47 in} ) between each hub bolt and the hub nut, then tighten all the hub nuts.
- After tightening all the hub nuts to the same torque, put the dial gauge on the friction surface of the disc plate 10 mm {0.39 in} from the disc plate edge.
- Rotate the disc plate one time and measure the runout.
Front disc plate runout limit
- 0.04 mm {0.002 in}