Diagnostic Procedure
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | Go to the next step. | ||
| 2 | VERIFY ALL SYSTEM DTCs
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 4. | ||
| 3 | VERIFY ALL SYSTEM DTCs AGAIN
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | RESET CONFIGURATION DATA FROM INSTRUMENT CLUSTER TO AUDIO AMPLIFIER
|
Yes | Replace the audio amplifier, then go to the next step. (See AUDIO AMPLIFIER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [AUDIO AMPLIFIER] .) |
| No | DTC troubleshooting completed. | ||