DTC C1A67-54; Radar Unit Aiming Adjustment Not Implemented: Notes

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION & POSSIBLE CAUSE

Description	Radar unit aiming adjustment not implemented
Detection condition	Radar unit aiming adjustment is not performed
Fail-safe	Inhibits the mazda radar cruise control (MRCC) system control Inhibits the smart brake support (SBS) system control Inhibits the distance recognition support system (DRSS) control
Possible cause	Radar unit aiming adjustment not performed The radar unit which had already been installed on another vehicle is installed on a different vehicle. NOTE: If the ignition is switched off when an error occurs during the aiming adjustment command execution, a DTC is detected indicating that the aiming adjustment was not performed.
System wiring diagram	Not applicable