DTC C0063-54; MAZDA Radar Cruise Control (MRCC) System Initialization Not Implemented: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CONDITION
| Description |
Mazda radar cruise control (MRCC) system initialization not implemented |
| Detection condition |
- The initial setting for yaw rate information is not performed after replacing the SAS control module.
NOTE:
- If the ignition is switched off when an error occurs during the system initialization command execution, a DTC is detected indicating that the system initialization was not performed.
|
| Fail-safe |
- Inhibits the mazda radar cruise control (MRCC) system control
- Inhibits the smart brake support (SBS) system control
- Inhibits the distance recognition support system (DRSS) control
|
| Possible cause |
- Mazda radar cruise control (MRCC) system initialization not performed after replacing SAS control module
- DTCs are stored in the SAS control module.
- SAS control module malfunction
- Radar unit malfunction
|
| System wiring diagram |
Not applicable |