Rear washer hose A installation note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

When installing rear washer hose A to the washer tank hook, align the upper part of the yellow mark with the hook and install. (world manufacturer identification "JM1")
When installing rear washer hose A to the washer tank hook, align the upper part of the gray mark with the hook and install. (world manufacturer identification "3MZ")

Fig 1: Aligning Upper Part Of Yellow Mark With Hook

Courtesy of MAZDA MOTORS CORP.