Using center display
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Input the diagnostic assist code by pressing the "Diagnostic assist code input switch".
- Press "ENTER".
- Perform inspection according to diagnostic assist code list. (See DIAGNOSTIC ASSIST CODE LIST .)CAUTION:
- If [- REJECTED] is displayed, the inspection cannot be performed because communication is not enabled between the related parts, or the conditions are not met even if communication is enabled.
[- REJECTED] is displayed
- Switch the ignition off.
- Launch the diagnostic assist function. (See ACTIVATION PROCEDURE .)
- Input the diagnostic assist code. (See DIAGNOSTIC ASSIST CODE INPUT PROCEDURE .)
- Verify that [- REJECTED] is not displayed.
- If [- REJECTED] is displayed, perform the DTC inspection or inspect the part related to the diagnostic content. (See DTC INSPECTION [CONNECTIVITY MASTER UNIT] .)