DTC P0761; Shift Solenoid No. 3 Stuck Off: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE
| DTC P0761:00 |
|
| DETECTION CONDITION |
- Under the following conditions, shift solenoid No. 3 stuck-off detected by combination of gear ratio malfunction and oil pressure switch pattern malfunction:
- Engine is running.
- ATF temperature is 20 °C {68 °F} or more.
- There is no difference between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal.
- Turbine/input shaft speed sensor and output shaft speed sensor DTC is not recorded.
|
| FAIL-SAFE FUNCTION |
- Inhibits malfunctioning gear.
- Limits engine torque.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
|
| POSSIBLE CAUSE |
- Shift solenoid No. 3 malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |