LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Automatic Transaxle System (Service Information)) >> Oil Cooler Removal/Installation >> Water Hose >> Water Hose No. 1 and No. 2 (oil cooler side) Installation Note

Water Hose No. 1 and No. 2 (oil cooler side) Installation Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the water hose to the oil cooler as shown in the figure with the hose clamp expanded.
    NOTE:
    • A new water hose and hose clamp are attached.
    Fig 1: Installing Water Hose To Oil Cooler
    G09075554Courtesy of MAZDA MOTORS CORP.
  2. Install the hose clamp so that center A of the hose clamp tab is within the range shown in the figure.
    Fig 2: Checking Hose Clamp A Range Measurement
    G09786179Courtesy of MAZDA MOTORS CORP.
    • Verify that the installation angle of the hose clamp is within the range shown in the figure.
  3. Verify that the hose clamp does not interfere with any other components.
scientia non olet · About LEMON Manuals