Dynamic Damper Assembly Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Apply soapy water to the inside of the dynamic damper.
Assemble the dynamic damper using the SST, spacers (such as spare nuts), and a press.

Fig 1: Assembling Dynamic Damper Using SST And Spacers (Spare Nuts)
Courtesy of MAZDA MOTORS CORP.
Verify that the installation position of the dynamic damper is within the specification.

Fig 2: Dynamic Damper Installation Position Specification

Courtesy of MAZDA MOTORS CORP.

Specification

LH: 271-277 mm {10.7-10.9 in}

RH: 154-160 mm {6.07-6.29 in}