LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Drive Axle Shaft) >> Front Drive Shaft (Double Offset Joint) Disassembly/Assembly >> Boot (Wheel Side) Disassembly Note

Boot (Wheel Side) Disassembly Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wrap vinyl tape around the spline area of the shaft to prevent damage to the boot.
    Fig 1: Vinyl Tape Around Spline Area Of Boot (Transaxle Side) Shaft
    G09759048Courtesy of MAZDA MOTORS CORP.
  2. Remove the boot (wheel side).
  3. Wipe off grease on the boot (wheel side) and ball joint using a clean rag.
scientia non olet · About LEMON Manuals