Mid-drive aiming (Dynamic aiming)
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Empty the vehicle by having all occupants leave the vehicle and remove all the cargo except for the spare tire, jack and tools.
- Adjust the air pressure of each tire to the specified value. (See WHEEL AND TIRE SPECIFICATION .)
- Connect the M-MDS to the DLC-2.
- Perform the DTC inspection for the FSC using the M-MDS and verify that no DTCs other than B115E:54 are displayed. (See DTC INSPECTION [FORWARD SENSING CAMERA (FSC)]
.)NOTE:
- Because DTC B115E:54 is output if aiming is not performed, continue to perform the FSC aiming if only DTC B115E:54 is output. (See DTC TABLE [FORWARD SENSING CAMERA (FSC)] .)
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- "Electrical"
- "FSC Aiming"
- "Dynamic Aming"
NOTE:- When in mid-drive aiming (dynamic aiming) mode, the LDWS warning light, HBC warning light, and SCBS warning light flash.
- Drive the vehicle on a road and verify that the warning lights in the instrument cluster turn off.