LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (On-Board Diagnostic - Dynamic Stability Control (DSC)) >> DTC C1031-41; Tire Pressure Monitoring System (TPMS) System >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INITIALIZE A TPMS MEMORY
  • Switch the ignition to off.
  • Connect the M-MDS (IDS) to DLC-2.
  • After the vehicle is identified, select the following items from the initial screen of the IDS.
    1. Select "Chassis".
    2. Select "ABS/DSC".
    3. Select "TPMS Reset".
  • Perform the procedure according to the directions on the screen.
  • Is the initialization normally completed?
 Yes Go to the next step.
No Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION .)
2 VERIFY THAT THE SAME DTC IS NOT PRESENT Yes Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
(See DSC HU/CM REMOVAL/INSTALLATION .)
No Go to the next step.
3 VERIFY THAT NO OTHER DTCS ARE PRESENT
  • Are any other DTCs output?
 Yes Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals