DTC C0061-54; C0062:54; C0063-54; DSC HU/CM system (UNPERFORMED INITIALIZATION PROCEDURES)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION & POSSIBLE CAUSE

DTC	C0061:54, C0062:54, C0063:54	DSC HU/CM system (unperformed initialization procedure)
DETECTION CONDITION		C0061:54 DSC HU/CM detects that the initialization procedure has not been performed. (Lateral acceleration sensor) C0062:54 DSC HU/CM detects that the initialization procedure has not been performed. (Longitudinal acceleration sensor) C0063:54 DSC HU/CM detects that the initialization procedure has not been performed. (Yaw rate sensor)
FAIL-SAFE FUNCTION		C0061:54, C0063:54 Illuminates the TCS/DSC indicator light, and smart city brake support (SCBS) indicator light (amber) 1. Tire pressure monitoring system warning light 1 illuminates after flashes. (Not illuminated/flashed depending on malfunction content.) Inhibits the TCS, DSC, TPMS 1, and smart city brake support (SCBS) 1 controls. C0062:54 Illuminates the TCS/DSC indicator light. Inhibits the hill launch assist (HLA) control. *1: If equipped.
POSSIBLE CAUSE		Initialization procedure for the lateral acceleration sensor, longitudinal acceleration sensor or yaw rate sensor not performed SAS control module malfunction DSC HU/CM malfunction
SYSTEM WIRING DIAGRAM		Not applicable

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY INITIALIZATION PROCEDURE Was the DSC related parts sensor initialization procedure performed?	Yes	Go to the next step.
1		No	Perform the DSC related parts sensor initialization procedure, then go to Step 3. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .)
2	INSPECT SAS CONTROL MODULE MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the SAS control module. (See DTC INSPECTION [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)] .) (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)] .) (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)] .)
2		No	Go to the next step.
3	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
4		No	DTC troubleshooting completed.