DTC C0061-28; C0061-64; C0062-28; C0062-64; C0063-28; C0063-64; SAS cONTROL MODULE SYSTEMS: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE
| DTC |
C0061:28, C0061:64, C0062:28, C0062:64, C0063:28, C0063:64 |
SAS control module system |
| DETECTION CONDITION |
NOTE:
- The low-G sensor and the yaw rate sensor are built into the SAS control module.
- C0061:28, C0061:64
- Out-of-specification signal modulation or lateral-G value is detected from the low-Gsensor.
- C0062:28, C0062:64
- Out-of-specification signal modulation or longitudinal-G value is detected from the low-Gsensor.
- C0063:28, C0063:64
- Out-of-specification signal modulation or yaw rate value is detected from the yaw rate sensor.
|
| FAIL-SAFE FUNCTION |
- C0061:28, C0061:64, C0063:28, C0063:64
- Illuminates the TCS/DSC indicator light and smart city brake support (SCBS) indicator light (amber) *1.
- Tire pressure monitoring system warning light *1 illuminates after flashes.
- Inhibits the TCS, DSC, TPMS *1, and smart city brake support (SCBS) *1 controls.
- C0062:28, C0062:64
- Illuminates the TCS/DSC indicator light.
- Inhibits the hill launch assist (HLA) control.
*1: If equipped. |
| POSSIBLE CAUSE |
- SAS control module malfunction
- DSC HU/CM malfunction
- Poor connection at connectors (female terminal)
|
| SYSTEM WIRING DIAGRAM |
Not applicable |