DTC C200D-1C; C200D-64; U2011-19; U2011-1C; U2011-62; U2011-72; U2011-92; EPS Motor Malfunction: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE
| DTC C200D:1C, C200D:64, U2011:19, U2011:1C, U2011:62, U2011:72, U2011:92 |
EPS motor |
| DETECTION CONDITION |
- C200D:1C
- Malfunction detected in resolver sensor internal circuit
- C200D:64
- Signal error detected in resolver sensor signal
- U2011:19, U2011:1C, U2011:62, U2011:72
- Malfunction detected in EPS motor internal circuit
- U2011:92
- Malfunction detected in EPS motor internal circuit in the backup control
|
| FAIL-SAFE FUNCTION |
- C200D:1C
- Control is maintained in the backup control (if EPS system internal temperature increases, the assist force gradually weakens)
- Power steering malfunction indicator light: Flashes (0.5 Hz)
- Power steering warning buzzer: sounds intermittently (0.5 Hz)
- If EPS system internal temperature increases above the specified value, the flashing interval for the power steering malfunction indicator light and the power steering warning buzzer sound interval are shortened (from 0.5 Hz to 2.0 Hz)
- If EPS system internal temperature increases further, the power steering malfunction indicator light switches from flashing to illumination and the power steering warning buzzer sounds continuously
- If EPS system overheating continues, the EPC CM disables assistance and stops the power steering warning buzzer (the power steering malfunction indicator light remains illuminated)
- C200D:64, U2011:19, U2011:1C, U2011:62
- Control disabled
- Power steering malfunction indicator light: Illuminated
- U2011:72
- An open circuit malfunction is detected in the one phase of the three-phase stator in the EPS motor
- Control is maintained in the backup control
- Other malfunction detected in EPS motor internal circuit
- Power steering malfunction indicator light: Illuminated
- U2011:92
- Control disabled
- Power steering malfunction indicator light: Illuminated
|
| POSSIBLE CAUSE |
- Malfunction in internal steering column, EPS motor
|
| SYSTEM WIRING DIAGRAM |
- |