Pilot bearing installation note (SKYACTIV-G 2.0)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Install new pilot bearing to the specified position using the following tools.

Fig 1: Installing Pilot Bearing
Courtesy of MAZDA MOTORS CORP.

Tool

Snap-on brand millimeter size bushing driver set (A160M) adapter A160M7 (20-22 mm)
- Use the adapter with the 20 mm side of the A160M7 (20-22 mm) facing the pilot bearing side.
  Substitution tool
  
  Outer diameter: 21 mm {0.83 in}
  
  Inner diameter: 19 mm {0.75 in}
  
  Standard position
  
  Distance A of pilot bearing from crankshaft end: 1.5-2.5 mm {0.060-0.098 in}
Fig 2: Checking Distance A Of Pilot Bearing From Crankshaft End
Courtesy of MAZDA MOTORS CORP.