Clutch disc and clutch cover installation note (SKYACTIV-G 2.0)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Hold the clutch disc position using the SST (49 SE01 310A).

Fig 1: Holding Clutch Disc Position Using SST (49 SE01 310A)
Courtesy of MAZDA MOTORS CORP.
Hold the clutch unit using the SST (49 E011 1A0).

Fig 2: Holding Clutch Unit Using SST (49 E011 1A0)
Courtesy of MAZDA MOTORS CORP.
Tighten the bolts in Min. 2 stages.
1. Temporarily tighten the bolts in the order shown in the figure.
  
  Fig 3: Holding Clutch Unit Using SST (49 E011 1A0)
  Courtesy of MAZDA MOTORS CORP.
2. Tighten the bolts completely in two or three steps in the order shown in the figure and install the clutch disc and cover.
Tightening torque

25-33 N.m {2.6-3.3 kgf.m, 19-24 ft.lbf}
Remove the SSTs (49 SE01 310A, 49 E011 1A0).