Diagnostic Procedure
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | INSPECT STEERING ANGLE SENSOR
|
Yes | Go to the next step. |
| No | Replace the steering angle sensor, then go to the next step. (See CLOCK SPRING REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) (See CLOCK SPRING REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM] .) |
||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT] .) |
| No | DTC troubleshooting completed. | ||