U.S.A. and Puerto Rico
WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not select "Flexible" under the following driving conditions.
- The vehicle is used as a police car, taxi, or for driving instruction.
- The vehicle is driven under dusty conditions.
- The vehicle is idled or driven at low speeds for extended periods.
Using M-MDS
- Connect the M-MDS (IDS) to DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Powertrain"
- Select the "Engine Oil Maintenance Monitor"
- Select the "Change setting"
- Select "ON*1" or "OFF" from the M-MDS screen.
*1 When oil inspection/replacement is set to "ON", the engine oil deterioration condition is calculated based on the frequency of engine starts and the distance travelled. Because the engine oil deterioration condition cannot be calculated correctly if engine oil other than Mazda genuine oil (0W-20) or Castrol oil (0W-20) is used, use Mazda genuine oil (0W-20) or Castrol oil (0W-20) when setting the oil inspection/replacement to "ON".
Using center display
- Switch the ignition ON (engine off or on).
- Select [Applications] on the center display.
- Select [Oil Change] on the center display.
- Select the following items and change the setting.
| Display of center display | Function | Initial setting | Setting contents | Control unit | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Setting | Display (Fixed, Flexible)/non-display of the oil inspection/replacement can be set. | Off | Off/Fixed/Flexible(1) | Connectivity master unit | ||||||
| Distance(2) | Distance to display of oil inspection/replacement can be set. | 8, 000 km/5, 000 miles | 0-99500 km (0-99750 miles) | Connectivity master unit | ||||||
| Oil Life(3) | Oil life to oil inspection/replacement can be displayed. | 100% | - | Connectivity master unit | ||||||
| Reset | Maintenance monitor setting can be reset to the initial value. | Back | Back/Reset | Connectivity master unit | ||||||
|
||||||||||