LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (On-Board Diagnostic - Front Body Control Module (FBCM)) >> DTC U0338-09; Error Light Switch Signal Received From Start Stop Unit >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

Step Inspection Action
1 VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN Yes Go to the next step.
No Go to Step 6.
2 VERIFY START STOP UNIT DTCs Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [START STOP UNIT] .)
No Go to the next step.
3 INSPECT LIGHT SWITCH Yes Go to the next step.
No Replace the light switch, then go to Step 5.
(See LIGHT SWITCH REMOVAL/INSTALLATION .)
4 PERFORM DTC INSPECTION AND VERIFY START STOP UNIT MALFUNCTION Yes Replace the start stop unit, then go to the next step.
(See START STOP UNIT REMOVAL/INSTALLATION .)
No Go to Step 6.
5 VERIFY THAT REPAIRS HAVE BEEN COMPLETED Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
6 VERIFY IF OTHER DTCs DISPLAYED
  • Are any other DTCs displayed?
Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)] .)
No DTC troubleshooting completed.