Repeatability Verification Procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Set the remaining fuel quantity in the fuel tank between 30-85 %.
Verify that OBD-II information (such as FREEZE FRAME DATA (Mode 2)) has been obtained and recorded.
Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .)
Start the engine and switch the ignition off after 5 shave elapsed.
Leave the vehicle for 6 hours or more.
Start the engine and leave it idling for 2 min.
Drive the vehicle for 30 min at a speed of 50 km/h {31 mph} or more(to increase temperature in fuel tank and generate evaporative gas).
NOTE:
- If driving the vehicle for 30 min at a speed of 50 km/h {31 mph} or more is not feasible, the vehicle can be driven for a continuous 15 min or more with the engine coolant temperature at 80 °C {176 °F} or more.
Stop the engine.
Leave the vehicle for 1 hours or more.