LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (On-Board Diagnostic - Engine Control (3 Of 5)) >> DTC P0442; P0455; P0456: Pcm Evaporative Gas Leakages >> Details On DTCs

Details On DTCs

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE

DESCRIPTION P0442:00
  • Evaporative gas leakage (leakage amount: low)

    P0455:00

  • Evaporative gas leakage (leakage amount: large)

    P0456:00

  • Evaporative gas leakage (leakage amount: extremely low)
DETECTION CONDITION Determination conditions P0442:00
  • Hole of 0.04 in (1.0 mm) or more in evaporative gas passage
P0455:00
  • Hole of 0.09 in (2.25 mm) or more in evaporative gas passage
P0456:00
  • Hole of 0.02 in (0.5 mm) or more in evaporative gas passage
Preconditions P0442:00, P0455:00
  • Period ignition is switched off before engine starts: 120 min or more
  • Engine coolant temperature at engine start: 2-43 °C {36-109 °F}(1)
  • Time elapsed from engine start: 6-90 min
  • Fuel level in fuel tank: 10-90 %(1)
  • Desired ambient air temperature: 4.4-43.3 °C {40-109 °F}(1)
  • Barometric pressure: 72.23 kPa {0.7365 kgf/cm2 , 10.48 psi} or more(1)
  • Charging efficiency: 3-65 %(1)
  • Vehicle speed: 64-144 km/h {40.0-89.4 mph}(1)

    P0456:00

  • Engine coolant temperature at engine start: 2-43 °C {36-109 °F}(1)
  • Intake air temperature at engine start: 7 °C {13 °F} or more higher than engine coolant temperature at engine start (1)
  • Time elapsed from engine start: 15-90 min
  • Fuel level in fuel tank: 10-90 %(1)
  • Desired ambient air temperature: 5-37 °C {41-98 °F}(1)
  • Barometric pressure: 72.35 kPa {0.7378 kgf/cm2 , 10.49 psi} or more(1)
  • Battery voltage: above 10 V(1)
  • The following DTCs are not detected:
    • Fuel tank pressure sensor: P0451:00, P0452:00,

    P0453:00

  • Purge solenoid valve: P0443:00
  • CV solenoid valve: P0446:00
  • EVAP monitor: P0442:00, P0455:00, P0457:00, P144A:00, P1450:00
    • Fuel gauge sender unit: P0460:00, P0461:00, P0462:00, P0463:00
Malfunction determination period
  • 75 s period
Drive cycle
  • 2
Self test type
  • CMDTC self test
Sensor used
  • Fuel tank pressure sensor
FAIL-SAFE FUNCTION
  • Not applicable
VEHICLE STATUS WHEN DTCs ARE OUTPUT
  • Illuminates check engine light.
POSSIBLE CAUSE
  • Missing or loose fuel filler cap
  • Fuel filler cap malfunction
  • Fuel tank pressure sensor malfunction
  • CV solenoid valve malfunction
  • Purge solenoid valve malfunction
  • Evaporative gas passage malfunction
    • Improper connection of evaporative hose
      • Evaporative hose damaged
  • Charcoal canister malfunction
  • Catch tank malfunction
  • Fuel pump unit loose
  • Fuel tank malfunction
  • PCM malfunction
(1) Value can be verified by displaying PIDs using M-MDS