DTC P2610-00; Malfunction In Instrument Cluster: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P2610:00 |
Malfunction in instrument cluster |
| DETECTION CONDITION |
- Malfunction detected in instrument cluster.
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
- The fast idle up correction for the drive-by-wire control is inhibited.
|
| POSSIBLE CAUSE |
- Instrument cluster power supply circuit malfunction (in this case, the instrument cluster records DTC U3003:16.)
- Instrument cluster malfunction
- PCM malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |