DTC P2110-00; Throttle Valve Actuator Control System-Forced Limited Rpm: Notes
WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION & POSSIBLE CAUSE
| DTC P2110:00 |
Throttle valve actuator control system-forced limited RPM |
| DETECTION CONDITION |
- PCM internal malfunction.
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
- Restricts the upper limit of the engine speed.
- Stops the drive-by-wire control (throttle valve is open at approx. 8 ° by return spring force).
|
| POSSIBLE CAUSE |
- Throttle body malfunction
- PCM malfunction
- Throttle valve actuator control module internal processor error (built-into PCM)
- Fuel injector control driver internal processor error (built-into PCM)
|
| SYSTEM WIRING DIAGRAM |
Not applicable |