Evaporative system test procedure

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Verify that all PIDs are within the following specifications.

Fig 1: PID Specifications
Courtesy of MAZDA MOTORS CORP.
NOTE:
- To successfully perform this procedure, all PIDs must be within specifications before proceeding to the next step.
Select the following items from the initialization screen of the M-MDS.
1. Select "Powertrain".
2. Select "Fuel".
3. Select "EVAP Test".
  - Verify that the ECT and IAT are within specifications on the confirmation screen. To successfully perform this procedure, the ECT and IAT must be within the specification before proceeding to the next step.
  - The fuel Level must be maintained within 15 %-85 %. The PCM will cancel the EVAP test if the fuel level is lower than 15 %or higher than 85 %.
Verify the test results described on the M-MDS and follow the instructions.