LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Wheel Hubs - Rear) >> Rear Wheel Hub Bolt Replacement

Rear Wheel Hub Bolt Replacement

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the following procedure for vehicles with the electric parking brake.
    1. Switch the ignition ON (engine off).
    2. Release the electric parking brake.
    3. Switch the ignition off.
    4. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
  3. Disconnect the electric parking brake motor gear unit connector. (With electric parking brake) (See ELECTRIC PARKING BRAKE MOTOR GEAR UNIT REMOVAL/INSTALLATION .)
  4. Remove the brake caliper component and disc plate. (See WHEEL HUB COMPONENT REMOVAL/INSTALLATION .)
  5. Remove the wheel hub bolt using the SST as shown in the figure.
    Fig 1: Removing Wheel Hub Bolt Using SST
    G06725056Courtesy of MAZDA MOTORS CORP.
  6. Place a new wheel hub bolt in the wheel hub.
  7. Install the wheel hub by placing a proper sized washer on the hub, and tightening the nut as shown in the figure.
Fig 2: Placing Wheel Hub Bolt In Wheel Hub
G09074835Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals